HP T9576G06 Management Manual page 318

TCP/IP Subagent
ZEMS-VAL-reason
indicates the reason the interface with the EMS collector process has become
unavailable. The DDL AS clause associated with this value is inserted in the
message text following "cause."
Value of
ZEMS-TKN-CHANGE-REASON
ZEMS-VAL-UNDERLYING-FAILED
ZEMS-VAL-OPERATOR-INITIATED
ZTSA-VAL-STATE-state
Indicates the previous state of the interface with the EMS collector process. The
DDL AS clause associated with this value is inserted in the message text following
"previous state."
Value of
ZEMS-TKN-STATE-PREVIOUS
ZTSA-VAL-STATE-CONNECTED
ZTSA-VAL-STATE-DISCONNECTED
ZTSA-VAL-STATE-ENABLED
ZTSA-VAL-STATE-DISABLED
ZTSA-VAL-STATE-DISCONNECTED
indicates the current state of the interface with the EMS collector process. The
DDL AS clause of this value ("disconnected," described in the preceding table)
appears in the message text following "current state."
SNMP Configuration and Management Manual—424777-006
1008: ZTSA-EVT-EMSCOLL-OBJ-UNAVAIL
Associated Text (DDL AS Clause) and
Meaning
"underlying-serv-failed" indicates that an
underlying service the interface with the EMS
collector process depends on has failed.
"operator-initiated" indicates that an operator
has taken the EMS collector process out of
service.
Associated Text (DDL AS Clause)
"connected" indicates a normal operational
state.
"disconnected" indicates a nonoperational
state where subagent function dependent on
the interface is not available.
"enabled" indicates that the interface has
been set by an operator such that the
subagent immediately attempts to restore it to
a connected state.
"disabled" indicates that the interface has
been taken out of service explicitly by an
operator setting the ztsaEmsCollectorState
MIB object to "disabled."
8- 88