Creating A Manual Mode Link Aggregate; Nwmgr Verbose Output (Link Aggregate); Nwmgr All Attributes Output (Link Aggregate) - HP -UX 11i v3 Administrator's Manual

Example 5-3 nwmgr Verbose Output (Link Aggregate)
# nwmgr -S apa -I 920 -v
lan920 current values:
Speed = 2 Gbps Full Duplex
MTU = 1500
Virtual Maximum Transmission Unit = 0
MAC Address = 0x00127942FC38
Network Management ID = 46
Features = Linkagg Interface
IPV4 Recv CKO
IPV4 Send CKO
VLAN Support
VLAN Tag Offload
64Bit MIB Support
Load Distribution Algorithm = LB_MAC
Mode = LACP_AUTO
Parent PPA = -
APA State = Up
Membership = 13,14
Active Port(s) = 13,14
Not Ready Port(s) = -
Key = 920
Operational Key = 920
Example 5-4 nwmgr All Attributes Output (Link Aggregate)
# nwmgr -S apa -I 920 -A all
lan920 current values:
Speed = 2 Gbps Full Duplex
MTU = 1500
Virtual Maximum Transmission Unit = 0
MAC Address = 0x00127942FC38
Network Management ID = 46
Features = Linkagg Interface
IPV4 Recv CKO
IPV4 Send CKO
VLAN Support
VLAN Tag Offload
64Bit MIB Support
Load Distribution Algorithm = LB_MAC
Mode = LACP_AUTO
Parent PPA = -
APA State = Up
Membership = 13,14
Active Port(s) = 13,14
Not Ready Port(s) = -
Group Capability = 5
Key = 920
Operational Key = 920
Polling Interval = 0
Dead Count = 0
Rapid ARP = off
Rapid ARP Interval = 0.0 second(s)
Rapid ARP Count = 0
Failover Policy = -

Creating a MANUAL mode link aggregate

To create a MANUAL mode link aggregate lan900 from ports lan1 and lan2, enter the
following command:
# nwmgr -a -A links=1,2 -A mode=MANUAL -I 900 -S apa
Addition of links 1, 2 to lan900 succeeded.
HP APA tasks and the nwmgr command 53