Start Trapdest Command - HP T9576G06 Management Manual

SCF Commands for the SNMP Agent
[$agent-process.]#endpoint-name
identifies the authentication table entry to activate.
$agent-process
identifies the NonStop agent process to which the PROFILE object belongs. It
consists of a dollar sign ($) followed by one to five alphanumeric characters,
the first of which must be alphabetic.
#profile-name
identifies the PROFILE object. It consists of a pound sign (#) followed by one
to seven alphanumeric characters, the first of which must be alphabetic.
Example: START PROFILE
The following example activates all entries in the authentication table used by NonStop
agent process $ZSNMP:
-> START PROFILE $ZSNMP.*

START TRAPDEST Command

Use the START TRAPDEST command to activate the sending of traps to a defined
trap destination.
START TRAPDEST [$agent-process.]#trapdest-name
[$agent-process.]#trapdest-name
identifies the trap destination definition to activate.
$agent-process
identifies the NonStop agent process to which the TRAPDEST object belongs.
It consists of a dollar sign ($) followed by one to five alphanumeric characters,
the first of which must be alphabetic.
#trapdest-name
identifies the TRAPDEST object. It consists of a pound sign (#) followed by one
to seven alphanumeric characters, the first of which must be alphabetic.
Considerations: START TRAPDEST
When you START a TRAPDEST object, if an underlying resource is not available (such
as the TCP/IP process or one of its subnets), the TRAPDEST object enters the
STARTING state.
SNMP Configuration and Management Manual—424777-006
5- 27
START TRAPDEST Command