SNMP Agent PTrace Facility
PTrace Commands Supported by the NonStop Agent
The PTrace code consists of two modules. The first module contains the code shared
by all subsystems. The second contains the additional, subsystem-specific code that
actually displays the PTrace records. The following commands implemented by the first
PTrace module are supported by all subsystems:
ALLOW
COUNT
ENV
EXIT
Additional commands implemented by the subsystem-specific PTrace modules vary
from subsystem to subsystem. Of the commands that fall into the subsystem-
dependent category, the NonStop agent supports the following:
HEX
LABEL
OCTAL
For descriptions of these standard PTrace commands available to all subsystems, refer
to the PTrace Reference Manual.
PTrace Commands Not Supported by the NonStop Agent
The following subsystem-dependent PTrace commands are not supported by the
NonStop agent:
EBCDIC
FILTER
SETTRANSLATE
Subset of Useful NonStop Agent PTrace Commands
Table 6-1
lists and describes a subset of PTrace commands that are particularly useful
when formatting NonStop agent trace records using the PTrace facility. The SELECT
command establishes the criteria against which records are compared. The NEXT and
RECORD commands determine the range of records in the currently opened trace file
that will be examined.
Table 6-1. Summary of NonStop SNMP Agent PTrace Commands (page 1 of 2)
Command
Description
FROM
Opens the specified trace file
FC
LIMIT
FIND
LOG
FROM
NEXT
HELP
OBEY
DETAIL
SELECT
TEXT
Table 6-1
TEST
TRANSLATE
SNMP Configuration and Management Manual—424777-006
PTrace Commands Supported by the NonStop
OUT
PAGESIZE
RECORD
RESET
describes the SELECT command.
6 -5
Agent