HP T9576G06 Management Manual page 253

TCP/IP Subagent
Table 8-3. Private (ZTSA) MIB Objects Supported by the TCP/IP
Subagent (page 3 of 7)
Object and Attributes
ztsaBackupState*
1.3.6.1.4.1.169.3.202.13
read-write
INTEGER
ztsaSwitchToBackupNow
1.3.6.1.4.1.169.3.202.14
read-write
INTEGER
ztsaEmsCollectorName
1.3.6.1.4.1.169.3.202.15
read-write
DisplayString
(SIZE (0..15))
* See State Object/Resource Object Pairs
control or indicate the internal processing state of processes used by the subagent.
Definition
The state of the TCP/IP
Subagent backup
process.
Causes the TCP/IP
Subagent backup
process to take over and
a new backup process to
be created.
The name of the EMS
collector process to
which the TCP/IP
Subagent sends events
it generates.
on page 8-28 for information about TCP/IP Subagent objects that
SNMP Configuration and Management Manual—424777-006
Format and Derivation of Value
Following are valid states for the
backup process:
This value can be set with an
SNMP request as illustrated by
the state change diagram in
Figure 8-3
One of these values:
At startup, the subagent sets this
value to 0, but it can be changed
by an SNMP manager if the
TCP/IP Subagent was started
using the -b startup parameter.
Setting this object to 1 causes the
TCP/IP Subagent backup process
to take over and a new backup
process to be created.
Setting this object is permitted
only if ztsaBackupState* is
connected (1).
\node.$ems-collector
specified for the -c startup
parameter. After startup, the
value can be set by an SNMP
manager.
Setting this object is permitted
only if ztsaEmsCollectorState* is
disabled (3).
8- 23
ZTSA MIB Objects
connected (1)
disconnected (2)
disabled (3)
enabled (4)
on page 8-29.
autoProcessPairControl (0)
forceBackupTakeover (1)