Scan Density - Kyocera Mita KM-3050 Advanced Operation Manual

Scan Density

ADVANCED OPERATION GUIDE
Use the procedure below to adjust the scanning density when sending
scanned originals. You can adjust the scan density either automatically or
manually.
The table below shows the available settings.
Item
Manual density
adjustment
Auto density
adjustment
The procedure for adjusting the scanning density when sending a scanned
image is explained below.
1
Place the originals on the platen.
2
Press the Send key.
3
Press [Color/Image] and then [Density].
4
When selecting
manual density
adjustment, press [-
3] to [+3] (Lighter -
Darker) to adjust
density.
When selecting auto
density adjustment,
press [Auto].
5
Press [OK].
6
Specify the destination, and press the Start key to start sending.
Detail
Can set density using 7 or 13 levels.
Can set the optimal scan density according to
the density of original.
Ready to send.
Enter Destination.
Density
Auto
Press [OK] to display
Lighter
the image.
-3 -2
-2.5 -1.5
Add Shortcut
Status
Sending Functions
Destination
Darker
Normal
-1 0 +1 +2 +3
-0.5 +0.5 +1.5 +2.5
Cancel OK
10/5/2006
2-21
1
10:10