Auto Sleep - Kyocera Mita KM-3050 Advanced Operation Manual

Auto Sleep

ADVANCED OPERATION GUIDE
3
Press [+] or [–] to
enter the time until
Auto Panel Reset is
turned on.
You cannot use the
number keypad to
enter this value.
4
Press [OK].
If no job runs for a certain period of time, automatically enter Sleep Mode.
Refer to the Operation Guide for Sleep Mode.
Auto Sleep ON/OFF
Select whether to use Auto Sleep or not.
NOTE:
Time remaining before Auto Sleep can be modified as necessary.
Refer to Sleep Timer below about the procedures.
Use the procedure below to select the interface.
1
Press the System Menu key.
2
Press [ ], [Date/Timer] and then [Change] of Auto Sleep.
3
Press [Off] or [On].
4
Press [OK].
Sleep Timer
If you select [On] for Auto Sleep, set the amount of time to wait before Auto
Sleep. Options are between 1 and 240 minutes (every one minute).
Date/Timer - Reset Timer
Set the amount of time to wait before automatic panel reset.
Use [-]/[+] to enter a number.
(5 - 495)
Status
Date/Timer - Auto Sleep
Automatically enter Sleep Mode.
Off
Status
System Menu
sec.
Cancel OK
10/5/2006
On
Cancel OK
10/5/2006
6-73
10:10
10:10