Table of Contents
Advertisement
Printer
Parallel Interface
3-2
The parallel interface of this machine supports both bidirectional mode and
high speed mode. Normally, use the default setting [Auto] for parallel
interface.
The table below shows the available settings.
Item
Auto*
Normal
High Speed
Nibble (High
Speed)
Use the procedure below to select the interface.
1
Press the System Menu Key.
2
Press [System] > [Parallel] > [Change].
3
Select the type of
parallel interface to
be used.
4
Press [OK].
5
Press the Power key, and after confirming that the Power key/indicator
and memory indicator have turned off, turn the main power off and on.
Detail
The mode will be automatically changed
depending on the connected computer.
Normally, no change to the setting is required.
Communicate by the standard method of
Centronics interface.
It is possible to conduct high-speed data transfer
between this machine and the computer. (When
you cannot print properly even after connecting
this machine to the workstation, select this
mode.)
In conformity with IEEE1284 standard, send and
receive data at high speed. It supports
bidirectional communication and enables the
computer to read the status of this machine.
System - Parallel
Select parallel interface type.
Normal
High Speed
Auto
Status
ADVANCED OPERATION GUIDE
*: Default setting
Nibble(High)
Cancel
OK
10/5/2006
10:10
Advertisement
Table of Contents
