Serial Interface - Kyocera Mita KM-3050 Advanced Operation Manual

Serial Interface

ADVANCED OPERATION GUIDE
The serial interface can be mounted as an option. The table below shows
the available settings. Select the setting best suited to the computer's

serial interface.

Item
Baud Rate
Data Bits
Stop Bits
Parity
Protocol
Use the procedure below to select the interface.
1
Press the System Menu Key.
2
Press [System] > [Serial] > [Change].
3
Select the baud rate.
4
Press [OK].
5
In the same way as Steps 2 to 4, set the data bits, stop bits, parity and
protocol.
6
Press the Power key, and after confirming that the Power key/indicator
and memory indicator have turned off, turn the main power off and on.
Value
1,200 bps, 2,400 bps, 4,800 bps, 9,600 bps*,
19,200 bps, 38,400 bps, 57,600 bps, 115,200
bps
7 bits, 8 bits*
1 bit*, 2 bits
None*, Odd, Even, Ignore
DTR (positive), &XOn/XOff*, DTR (positive),
DTR (negative), XOn/XOff, ETX/ACK
System - Baud Rate
Set Baud rate for the serial interface.
1200bps 2400bps 4800bps
38400bps 57600bps 115200bps
Status
Printer
*: Default setting
9600bps 19200bps
Cancel OK
10/5/2006 10:10
3-3