Touch Panel Display After The Security Kit Is Installed - Kyocera Mita KM-3050 Advanced Operation Manual

Security

Touch Panel Display after the Security Kit is Installed

Hard Disk Icon Display
8-4
In Security Mode,
the security kit has
been properly
installed and is
running. The hard
disk icon appears on
the lower right side
of the touch panel in
Security Mode.
NOTE:
If the hard disk icon does not appear on the normal screen, it is
possible that the Security Mode is not ON. Call service.
The hard disk icon display changes as follows during overwriting
The table below shows the icons displayed and their descriptions.
Icon displayed
CAUTION:
Do not turn the main power switch off during overwriting (while
is displayed). It may crash the hard disk.
NOTE:
If you turn the machine off at the main power switch during
overwriting, data may not be overwritten completely from the hard disk.
Turn the machine back on at the main power switch. Overwriting
automatically resumes. If you accidentally turn the main power switch off
during overwriting or initialization, the hard disk icon might not switch to
the second icon shown above. This would be caused by a possible crash
or failed overwriting of the data to be overwritten. This will not affect
subsequent overwriting processes. However, system initialization is
recommended so as to return to normal stable operations. (Initialization
should be performed by the administrator following the steps in System
Initialization on page 8-8.)
Ready to copy.
Copy Image
Set Original.
Auto
Zoom
Original : - - -
Zoom : 100%
- - -
Paper : 1-sided Text+Photo
>>1-sided
Duplex
Preview
Quick Setup Org./Paper/
Finishing
Status
There is unwanted data on the hard
disk.
Overwriting the unwanted data
The unwanted data is overwritten.
ADVANCED OPERATION GUIDE
Copies
Interrupt
Normal 0 Letter
Plain
Density Paper
Selection
Collate
Original Collate/
Image Offset
Image Layout/Edit Advanced
Quality Setup
10/5/200 6
Description
1
10:10