Output Destination - Kyocera Mita KM-3050 Advanced Operation Manual

Output Destination

ADVANCED OPERATION GUIDE
You can use the procedure below to select an output destination such as
the optional document finisher for your copies.
NOTE:
Optional output destinations include the job separator, document
finisher, 3000 Sheet Document Finisher and the mailbox.
The table below shows the available output destinations.
Destination
Top tray
Finisher tray*
Tray A, Tray B*,
Tray C*
Job separator tray
Trays 1 to 7*
* Copy output orientation can be selected either as face-up (print
facing up) or face-down (print facing down).
NOTE:
To change default destination for copies, refer to Output Tray on
page 6-20 for details.
Use the procedure below to select the output destination.
1
Press the Copy key.
2
Press [Org./Paper/Finishing] and then [Output Tray].
3
Select the output destination for finished copies.
When you select any
of [Finisher tray],
[Tray B], [Tray C] or
[Trays 1 to 7], select
the orientation of
output copy, Face
Up (print facing up)
or Face Down (print
facing down).
Description
Top tray of the machine (where copies are
stored)
Tray of the optional document finisher or built-in
finisher
Tray A to C of the optional 3000 Sheet
Document Finisher
Optional job separator
Trays 1 to 7 of the optional mailbox (Tray 1 is the
top tray)
Ready to copy.
Output Tray
Press [OK] to display
the image.
Top Tray
Job Separator
Tray
Tray 4
Add Shortcut
Status
Copying Functions
Copies
Face Up
Face Down
Tray A Tray B Tray C
Tray 1 Tray 2 Tray 3
Tray 5 Tray 6 Tray 7
Cancel OK
10/5/2006
1-17
1
10:10