TCP/IP Setup (Equipped with DHCP Server)
NetWare Setup
ADVANCED OPERATION GUIDE
7
Press [Default Gateway] and enter the address using the numeric keys.
8
Check if all the address entries are correct and press [OK].
9
Press the Power key and confirm that the Power key/indicator and the
memory indicator are off. After that, turn the main power switch off and on.
Set up TCP/IP when the network is equipped with the DHCP server. The
machine works as the DHCP client. Use the procedure below to select the
interface.
1
Press the System Menu key.
2
Press [System], [Next] of Network and then [Change] of TCP/IP.
3
Press [On] on the
left side of the touch
panel.
4
Press [On] of DHCP.
5
Press [OK].
6
Press the Power key and confirm that the Power key/indicator and the
memory indicator are off. After that, turn the main power switch off and on.
Select the NetWare network connection. After that, select frame types for
NetWare network from Auto, Ethernet-II, 802.3, 802.2, or SNAP.
Use the procedure below to select the interface.
1
Press the System Menu key.
2
Press [System], [Next] of Network and then [Change] of NetWare.
System - TCP/IP
Use TCP/IP.
DHCP
Off
On
On
Off
Status
System Menu
IP Address
0.0.0.0
Subnet Mask
0.0.0.0
Default
0.0.0.0
Gateway
Cancel
OK
10/5/2006
10:10
6-57