Function Defaults - Kyocera Mita KM-3050 Advanced Operation Manual

Function Defaults

ADVANCED OPERATION GUIDE
4
Select Output Tray.
For [Finisher Tray],
[Tray B], [Tray C] or
[Tray 1-7], select
[Face Up] (print
surface up) or [Face
Down] (print surface
down) for paper
orientation at output.
5
Press [OK].
Defaults are the values automatically set after the warm-up is completed
or the Reset key is pressed.
Set the defaults for available settings such as copying and sending. Setting
the frequently-used values as defaults makes subsequent jobs easier.
Original Orientation
Set the original orientation defaults. The available default settings are
shown below.
Item
Top Edge Top
Top Edge Left
Refer to page 1-10 for Original Orientation.
Use the procedure below to select the default orientation when originals
are placed on the platen.
1
Press the System Menu key.
2
Press [Common Settings], [Next] of Function Defaults and then [Change]
of Original Orientation.
Common Settings - Copy/Custom Box
Select output tray for copy jobs.
Top Tray Tray A Tray B
Job Separator Tray 1 Tray 2
Tray
Tray 4 Tray 5 Tray 6
Status
Description
Select the original's top edge at the top.
Select the original's top edge at the left.
System Menu
Tray C
Output Face
Tray 3 Face Up
Tray 7 Face Down
Cancel OK
10/5/2006 10:10
6-21