9. Lift the structure out of the server, making sure that the front alignment tabs
Install the power supply structure by completing the following steps:
1. Align the tabs on the structure with the notches on the chassis; then, gently
2. Push the two blue latches of the power supply structure toward the rear of the
I/O board and power backplane assembly
This section shows the locations of items on the I/O board and contains information
about removing and replacing the I/O board and power backplane assembly.
Note: When replacing the I/O board, you must either update the server with the
The I/O board and power backplane share a single metal backerplate. To replace
either board, the backerplate assembly must be removed from the server.
I/O board connectors
The following illustration shows the connectors on the I/O board.
PCI-X slot 2
100 MHz 64-bit
PCI-X slot 3
133 MHz 64-bit
PCI-X slot 4
133 MHz 64-bit
PCI-X slot 5
133 MHz 64-bit
PCI-X slot 6
133 MHz 64-bit
slide clear of the chassis.
lower the back of the structure into the server, making sure to line up the two
posts on the floor of the chassis with the two apertures in the structure.
Notes:
a. The structure will fit snugly against the metal flange in the center of the I/O
board and power backplane assembly.
b. Do not allow any cables to be pinched or caught on metal protrusions.
server until they lock the structure into position.
latest firmware or restore the pre-existing firmware that the customer
provides on a diskette or CD image.
Ethernet 1 / USB 1 (J12)
Ethernet 2 / USB 2 (J15)
PCI slot 1
33 MHz 64-bit
RXE expansion (J11)
Chapter 5. FRU information (service only)
Mouse (J9)
Keyboard (J7)
Serial (J5)
RXE management (J3)
PCI switch card cable (J18)
Remote Supervisor
Adapter II cable (J16)
Battery
Media backplane cable (J13)
SCSI external cable (J21)
SCSI power (J14)
SCSI internal cable (J17)
79