Removing The Cover And Bezel - IBM 8862 - Eserver xSeries 365 Maintenance And Troubleshooting Manual

Removing the cover and bezel

Complete the following steps to remove the cover and bezel:
1. Read "Safety information" on page 147 and "Installation guidelines" on page 29.
2. If you are installing or replacing a non-hot-swap component, turn off the server
3. Slide the server out of the rack until the slide rails lock into place.
4. Lift the cover-release latch. The cover slides to the rear approximately 13 mm
5. Press on the bezel retention tabs at the top edge of the bezel, and pull the top
6. Lift the bezel up to release the two tabs at the bottom edge of the bezel.
32
IBM xSeries 365 Types 8861, 8862: Hardware Maintenance Manual and Troubleshooting Guide
and all attached peripheral devices. Disconnect all power cords; then,
disconnect all external signal cables from the server.
Top cover
Bezel
xS
eri es
36
5
(0.5 inch). Lift the cover off the server.
Attention: For proper server performance, do not leave the top cover off for
more than two minutes while the server is running.
of the bezel slightly away from the server.
Cover release
latch