Power Switch/Led Assembly - IBM IntelliStation M Pro 6225 Hardware Maintenance Manual And Troubleshooting Manual

Power switch/LED assembly

Before you begin:
v Read the "Installation guidelines" on page 29.
v Read Appendix B, "Safety information," on page 115.
v Review the information in "System reliability guidelines" on page 29.
To remove the power switch/LED assembly, complete the following steps:
1. Turn off the computer, if it is on.
2. Disconnect the power cord from the power source and from the computer; then,
3. Remove the side cover (see "Removing the side cover" on page 32).
4. Remove the front bezel (see "Removing and Installing the Bezel" on page 34).
5. Lay the computer on its left side.
6. Remove the microprocessor fan assembly (see "Removing and replacing the
7. Disconnect the LED cables from the system board and front I/O panel.
8. From the front of the computer, press the assembly retaining tab to the right and
To replace the power switch/LED assembly, reverse the previous steps.
76
IntelliStation M Pro Types 6225 and 6228: Hardware Maintenance Manual and Troubleshooting Guide
disconnect all external cables.
microprocessor fan assembly" on page 35).
Important: When disconnecting cables, note the cable routing and connector
labels for use during installation.
through the opening in the front panel; then, carefully lift the assembly out of the
computer from the inside.
Retaining tab