IBM 8862 - Eserver xSeries 365 Maintenance And Troubleshooting Manual page 122

Hardware maintenance manual and troubleshooting guide
Hide thumbs Also See for 8862 - Eserver xSeries 365:
Table of Contents

Advertisement

Note: See Chapter 7, "Parts listing, Types 8861, 8862," on page 139 to determine which components are
replaceable by the customer and which components must be replaced by an IBM field service technician.
Service Processor message
IP address of default gateway modified from
x.x.x.x
IP address of network interface modified
from x.x.x.x
IP subnet mask of network interface modified
from x.x.x.x
Loader Watchdog Triggered
Memory Port X Power Fault
Multiple fan failures
OS Watchdog Triggered
PFA Alert
POST Watchdog Triggered
Power Supply X 12V Over Current Fault
Power Supply X 12V Over Voltage Fault
Power Supply X 12V Under Voltage Fault
Power Supply X AC Power Removed
Power Supply X Current Fault
112
IBM xSeries 365 Types 8861, 8862: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
v Information only
v Information only
v Information only
1. Reconfigure Loader Watchdog timer to be a higher value
(twice the normal OS boot time).
2.
Install the Remote Supervisor Adapter II device driver for the
appropriate operating system.
3.
Disable the Loader Watchdog.
4.
Check integrity of the installed operating system.
5. Re-install the operating system with appropriate device drivers.
1. Verify that microprocessor tray assembly is fully engaged
with memory cassette.
2. Microprocessor tray assembly.
v Replace any missing or failed fans or power supplies.
1. Reconfigure O/S Watchdog timer to be a higher value.
2. Re-Install the Remote Supervisor Adapter II device driver for
the appropriate operating system.
3.
Disable the O/S Watchdog.
4.
Check integrity of the installed operating system.
5. Re-install the operating system with appropriate device drivers.
v See preceding entry in error log.
1. Reconfigure POST Watchdog timer to be a higher value
(consistent with time it takes to complete POST).
2.
Disable the POST Watchdog.
1. Power supply
2. Power backplane
1. Power supply
2. Power backplane
1. Power supply
2. Power backplane
1.
Insert the ac cord into power supply X.
2.
Replace power supply X.
1. Power supply
2. Power backplane

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xseries 365 8862Xseries 365 8861

Table of Contents