Table of Contents
Advertisement
Completing the installation
This section describes how to complete the installation.
Installing the cover and bezel
Complete the following steps to install the server cover and bezel:
1. Before installing the cover, check that all internal cables, adapters, and other
2. Move the cover-release latch to the open (up) position.
3. Position the cover on top of the server and press down on the cover-release
4. Insert the tabs on the cover into the matching slots in the server chassis and
5. Press down on the cover-release latch. The cover-release latch slides the cover
6. Insert the tabs on the bottom of the bezel into the matching holes on the server
7. Push the top of the bezel toward the server until the two tabs at the top of the
8. Slide the server fully into the rack cabinet.
9. If you disconnected any power cords or external cables from the server,
Note: Depending on the options that you installed, you might need to run the
58
IBM xSeries 365 Types 8861, 8862: Hardware Maintenance Manual and Troubleshooting Guide
components are installed and seated correctly and that you have not left loose
tools or parts inside the server.
Top cover
Bezel
xS
eri
es
36
5
latch. The cover slides forward into position.
slide the cover forward.
forward into position and locks the cover in place.
chassis.
sides of the bezel snap into place.
reconnect the external cables first. If you are adding any new peripheral devices
(see "Connecting the cables" on page 59 for details), you can then connect the
external cables from those devices. Then, connect the power cords to properly
grounded electrical outlets.
Configuration/Setup Utility program to update the server configuration. See
"Updating the server configuration" on page 60, "Using the
Configuration/Setup Utility program" on page 11, and the User's Guide for
more information.
Cover release
latch
Advertisement
Table of Contents
