Table of Contents
Advertisement
Adapter retainer bracket assembly
This section contains information about removing and replacing the adapter retainer
bracket assembly.
Note:
Complete the following steps to remove the adapter retainer bracket assembly:
1. Turn off the server and all peripheral devices; then, disconnect all power cords
2. Remove the top cover (see "Removing the cover and bezel" on page 32).
3. Lift up the latch mechanism.
4. Remove all adapters and adapter insulators (see "Removing a PCI or PCI-X
5. Disconnect one end of all cables that pass through the adapter bracket
6. Turn the two blue quarter-turn fasteners to release the bracket assembly.
7. Lift the bracket assembly out of the server.
When replacing the adapter bracket assembly, complete the following steps:
1. Align the two tabs on the bracket assembly with the two slots on the chassis.
2. Set the bracket assembly firmly into place before securing the quarter-turn
3. Reconnect the cables that were set aside in step 5 and route them back into the
4. Install the adapters and insulators that were removed in step 4.
5. When replacing the insulators, make sure that:
v Read "Installation guidelines" on page 29.
v Read "Safety information" on page 147.
v Read "Handling static-sensitive devices" on page 30.
and external cables.
adapter" on page 36), making sure to place the adapters on a static-protective
surface.
assembly; then, remove them from the routing feature of the bracket assembly
and fold them out of the way.
Quarter-turn
fasteners
fasteners.
routing feature of the adapter retention assembly.
Latch mechanism
Chapter 5. FRU information (service only)
77
Advertisement
Table of Contents
