Removing The Led Board; Removing The Scsi Backplane Assembly - IBM x 340 Series Hardware Maintenance Manual

Removing the LED board

Removing the SCSI backplane assembly

c 1 d
LED board
c 2 d
Screws(2)
To remove the LED board:
1. Remove the cover. See "Removing the cover and bezel" on page 47.
2. Disconnect the LED board cable from the system board .
Remove the two screws c 2 d .
3.
Carefully slide out the board c 1 d .
4.
c 1 d
Screw
c 2 d
SCSI Backplane
To remove the hot-swap hard disk drive backplane:
1. Remove the cover. See "Removing the cover and bezel" on page 47.
2. Disconnect cables.
Remove the screw c 1 d from the top of the assembly.
3.
Gently slide the SCSI backplane assembly c 2 d up to remove.
4.
FRU information (service only)
107