Table of Contents
Advertisement
6. To release the media interposer card from the chassis, press down on the two
7. Pull the media interposer card out of the server.
To install the media interposer card, reverse the preceding steps.
Note: When inserting the media interposer card into the server, angle the card so
SCSI backplane
This section contains information about removing and replacing the SCSI
backplane.
Note:
Complete the following steps to remove the SCSI backplane:
74
IBM xSeries 365 Types 8861, 8862: Hardware Maintenance Manual and Troubleshooting Guide
blue touchpoints on the rectangular steel flaps ( 1 ) that lie flush with the
chassis structure near the base of the media interposer card.
that the left side of the card goes in first and fits against the metal lip on the
chassis.
v Read "Installation guidelines" on page 29.
v Read "Safety information" on page 147.
v Read "Handling static-sensitive devices" on page 30.
1. Turn off the server and all peripheral devices; then, disconnect all power cords
and external cables.
2. Remove the top cover (see "Removing the cover and bezel" on page 32). It is
not necessary to remove the front bezel.
3. Pull the hard disk drives out of the server slightly to disengage them from the
SCSI backplane.
4. Disconnect the SCSI cable from the SCSI backplane.
5. Disconnect the cable connecting the I/O board to the media interposer card.
Note: This is the only cable that should be disconnected from the media
interposer card.
Advertisement
Table of Contents
