Table of Contents
Advertisement
Note: See Chapter 7, "Parts listing, Types 8861, 8862," on page 139 to determine which components are
replaceable by the customer and which components must be replaced by an IBM field service technician.
Error code/symptom
166-201-114 (ISMP indicates I2C errors on
RXE bus PCI_B slot 2)
166-201-115 (ISMP indicates I2C errors on
RXE bus PCI_B slot 3)
166-201-116 (ISMP indicates I2C errors on
RXE bus PCI_B slot 4)
166-201-117 (ISMP indicates I2C errors on
RXE bus PCI_B slot 5)
166-201-118 (ISMP indicates I2C errors on
RXE bus PCI_B slot 6)
166-260-000 (ASM restart failure)
166-342-000 (System Management BIST
indicates failed tests)
166-400-000 (ISMP Self Test Result failed
tests: xxx) where xxx=flash, ROM, or RAM
166-400-100 (DMC Self Test Result failed
tests: xxx) where xxx=flash, ROM, or RAM
180-197-000 (SCSI ASPI driver not
installed)
180-361-003 (Failed Fan LED test)
180-xxx-000 (Diagnostics LED failure)
180-xxx-001 (Failed Front LED Panel test) 1. Operator information panel cable
180-xxx-002 (Failed Diagnostics LED
Panel test)
100
IBM xSeries 365 Types 8861, 8862: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
v See Hardware Maintenance Manual for IBM RXE-100 Remote
Expansion Enclosure.
v See Hardware Maintenance Manual for IBM RXE-100 Remote
Expansion Enclosure.
v See Hardware Maintenance Manual for IBM RXE-100 Remote
Expansion Enclosure.
v See Hardware Maintenance Manual for IBM RXE-100 Remote
Expansion Enclosure.
v See Hardware Maintenance Manual for IBM RXE-100 Remote
Expansion Enclosure.
1. Disconnect all server and option power cords from server, wait
30 seconds, reconnect, and retry.
2. Remote Supervisor Adapter.
1. Disconnect all server and option power cords from server, wait
30 seconds, reconnect, and retry.
2. Remote Supervisor Adapter.
1. Disconnect all server and option power cords from server, wait
30 seconds, reconnect, and retry.
2. (Re)flash ISMP with latest firmware level.
3. I/O board.
1. Disconnect all server and option power cords from server, wait
30 seconds, reconnect, and retry.
2. (Re)flash ISMP on RXE with latest firmware level.
3. RXE backplane.
1. Remove RAID adapter, if installed, and rerun test.
2. SCSI backplane.
3. I/O board.
4. Microprocessor tray assembly.
1. Fan
2. I/O board
v Run diagnostic LED test for failing LED.
2. Operator information panel
3. I/O board
4. Microprocessor tray assembly
1. Operator information panel cable
2. Operator information panel
3. I/O board
4. Microprocessor tray assembly
Advertisement
Table of Contents
