Table of Contents
Advertisement
v A new problem occurs.
You can use the remind button to delay server maintenance until a later time.
Diagnostic programs and error messages
The diagnostic programs are in the system flash erasable programmable read-only
memory (EPROM) on the I/O board. These programs are the primary method of
testing the major components of the server.
Diagnostic error messages indicate that a problem exists; they are not intended to
be used to identify a failing part. Troubleshooting and servicing of complex
problems that are indicated by error messages should be performed by trained
service personnel.
Sometimes the first error to occur causes additional errors. In this case, the server
displays more than one error message. Always follow the suggested action
instructions for the first error message that appears.
Diagnostic text messages
While a test is running, the name of the test is displayed on the screen. If the test
detects an error or is abnormally ended, a message is displayed to indicate the
reason that the test stopped. The message is in the following form:
result test_specific_string
where:
result
test specific string
22
IBM xSeries 365 Types 8861, 8862: Hardware Maintenance Manual and Troubleshooting Guide
is one of the following results:
Passed
This test was completed without any errors.
Failed
This test discovered an error.
User Aborted
You stopped the test before it was completed.
Not Applicable
You attempted to test a device that is not present in the server.
Aborted
The test could not proceed because of the server configuration.
Warning
A possible problem was reported during the test (for example, a
device that was to be tested is not installed).
is an error code or other information about the error.
Advertisement
Table of Contents
