IBM 8862 - Eserver xSeries 365 Maintenance And Troubleshooting Manual page 100

Note: See Chapter 7, "Parts listing, Types 8861, 8862," on page 139 to determine which components are
replaceable by the customer and which components must be replaced by an IBM field service technician.
Error code/symptom
178x (Fixed Disk error)
1800 (Unavailable PCI hardware interrupt)
1962 (Drive does not contain a valid boot
sector)
5962 (IDE CD-ROM configuration error)
8603 (Pointing Device Error)
0001295 (ECC circuit check)
00012000 (Processor machine check error)
00019501 (Processor 1 is not functioning -
check VRM and processor LEDs)
00019502 (Processor 2 is not functioning -
check VRM and processor LEDs)
00019503 (Processor 3 is not functioning -
check VRM and processor LEDs)
00019504 (Processor 4 is not functioning -
check VRM and processor LEDs)
00019701 (Processor 1 failed BIST)
00019702 (Processor 2 failed BIST)
00019703 (Processor 3 failed BIST)
90
IBM xSeries 365 Types 8861, 8862: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
1. Hard disk drive cables.
2. Run diagnostic programs.
3. Hard disk drive adapter.
4. Hard disk drive.
5. I/O board.
1. Run Configuration/Setup and adjust adapter settings.
2. Remove an adapter.
1. Verify a bootable operating system is installed.
2. Run diagnostic programs.
3. Hard disk drive.
4. SCSI backplane.
5. Cable.
6. I/O board.
1. Run Configuration/Setup.
2. CD-ROM drive.
3. IDE cable.
4. I/O board.
1. Pointing device
2. I/O board
1. DIMM
2. Microprocessor tray assembly
1. Microprocessor
2. Microprocessor tray assembly
1. Microprocessor 1
2. Microprocessor tray assembly
1. Microprocessor 2
2. Microprocessor tray assembly
1. VRM 3
2. Microprocessor 3
3. Microprocessor tray assembly
1. VRM 4
2. Microprocessor 4
3. Microprocessor tray assembly
1. Microprocessor 1
2. Microprocessor tray assembly
1. Microprocessor 2
2. Microprocessor tray assembly
1. Microprocessor 3
2. VRM3
3. Microprocessor tray assembly