Power/Led Switch Assembly - IBM IntelliStation Z Pro 6223 Hardware Maintenance Manual And Troubleshooting Manual

Power/LED switch assembly

Before you begin:
v Read the "Installation guidelines" on page 23.
v Read Appendix B, "Safety information," on page 125.
v Review the information in "System reliability considerations" on page 23.
To remove the power/LED switch assembly, complete the following steps:
1. Turn off the computer, if it is on.
2. Disconnect the power cord from the power source and from the computer; then,
3. Remove the side cover (see "Removing the side cover" on page 25).
4. Remove the front bezel (see "Removing the bezel" on page 26).
5. Note where the power-switch and LED panel cable connects to the system
6. From inside the computer, press the release tab.
7. Pull the assembly toward the rear of the computer and remove it.
To replace the power/LED switch assembly, reverse the previous steps, making
sure that the assembly clicks into place in the chassis.
68
IntelliStation Z Pro Types 6223 and 6227: Hardware Maintenance Manual and Troubleshooting Guide
disconnect all external cables.
board; then, carefully disconnect the cable from the system board.
Note: See the system service label or "System board internal connectors" on
page 72 for system board connector locations.
Release tab