Cisco ACE-4710-K9 Administration Manual page 66

Modifying the Boot Configuration
When you boot the ACE for the first time and the appliance does not detect a
Note
startup-configuration file, a setup script appears to enable connectivity to the ACE
Device Manager GUI. The start-up script is not intended for use with the CLI.
Choose no to skip the use of the setup script and proceed directly to the CLI. See
the
section for details.
You may now configure the ACE to define basic configuration settings for the
appliance.
Cisco 4700 Series Application Control Engine Appliance Administration Guide
1-40
---- Basic System Configuration Dialog ----
This setup utility will guide you through the basic configuration
of
the system. Setup configures only enough connectivity to the
ACE appliance Device Manager GUI of the system.
*Note: setup is mainly used for configuring the system initially,
when no configuration is present. So setup always assumes system
defaults and not the current system configuration values.
Press Enter at anytime to skip a dialog. Use ctrl-c at anytime
to skip the remaining dialogs.
Would you like to enter the basic configuration dialog (yes/no):no
Cisco Application Control Software (ACSW)
TAC support: http://www.cisco.com/tac
Copyright (c) 1985-2007 by Cisco Systems, Inc. All rights
reserved.
The copyrights to certain works contained herein are owned by
other third parties and are used and distributed under license.
Some parts of this software are covered under the GNU Public
License. A copy of the license is available at
http://www.gnu.org/licenses/gpl.html.
"Using the Setup Script to Enable Connectivity to the Device Manager"
Chapter 1 Setting Up the ACE
OL-11157-01