Class Map And Policy Map Configuration Quick Start - Cisco ACE-4710-K9 Administration Manual

Class Map and Policy Map Configuration Quick Start

Class Map and Policy Map Configuration Quick Start
Cisco 4700 Series Application Control Engine Appliance Administration Guide
4-10
Table 4-1 and Table 4-2
a class map with match criteria that define Layer 3 and Layer 4 network traffic
classifications.
Table 4-1 describes the steps to define Layer 3 and Layer 4 traffic classes with
•
match criteria that identify the IP network traffic that can pass through the
ACE.
Table 4-2 describes the steps to define Layer 3 and Layer 4 network
•
management traffic that can be received by the ACE.
Each step includes the CLI command required to complete the task.
Table 4-1 Layer 3 and Layer 4 Network Traffic Class Configuration
Quick Start
Task and Command Example
If you are operating in multiple contexts, observe the CLI prompt to verify
1.
that you are operating in the desired context. If necessary, log directly in to,
or change to, the correct context.
host1/Admin# changeto C1
host1/C1#
The rest of the examples in this table use the Admin context, unless
otherwise specified. For details on creating contexts, see the Cisco 4700
Series Application Control Engine Appliance Virtualization Configuration
Guide.
Enter configuration mode.
2.
host1/Admin# config
Enter configuration commands, one per line. End with CNTL/Z
host1/Admin(config)#
Chapter 4
provide a quick overview of the steps required to create
Configuring Class Maps and Policy Maps
OL-11157-01