Clearing Redundancy Statistics
Clearing Redundancy Statistics
Note
Clearing FT Statistics
Clearing the Redundancy History
Cisco 4700 Series Application Control Engine Appliance Administration Guide
7-58
To clear redundancy statistics, use the commands described in the following
sections.
If you configure redundancy on the ACE, then you must explicitly clear statistics
on both the active and the standby ACEs. Clearing statistics on the active
appliance only does not clear the statistics on the standby appliance.
To clear redundancy heartbeat statistics, use the clear ft stats command in Exec
mode. When you enter this command for the first time, the ACE sets the FT
statistics counters to zero and stores a copy of the latest statistics locally. From
that point on, when you enter the show ft stats command, the ACE displays the
difference between the statistics stored locally and the current statistics. The
syntax of this command is:
clear ft stats
For example, enter:
host1/Admin# clear ft stats
To clear the redundancy history, use the clear ft history command in Exec mode
in the Admin context only. The syntax of this command is:
clear ft history {cfg_cntlr | ha_dp_mgr | ha_mgr}
The keywords are:
cfg_cntlr—Clears the Config Controller debug log
•
ha_dp_mgr—Clears the HA (redundancy) dataplane manager debug log
•
ha_mgr—Clears the HA (redundancy) manager debug log
•
For example, enter:
host1/Admin# clear ft history cfg_cntlr
Chapter 7
Configuring Redundant ACE Appliances
OL-11157-01