Cisco ACE-4710-K9 Administration Manual page 50

Synchronizing the ACE with an NTP Server
Only users who are authenticated in the Admin context can use the show ntp
Note
command.
The keywords, arguments, and options are:
•
•
•
•
•
•
•
•
For example, to display the status for all NTP servers and peers, enter:
switch/Admin# show ntp peer-status
Table 1-2
Table 1-2
Field
Total Peers
Remote
Local
St
Poll
Reach
Delay
Cisco 4700 Series Application Control Engine Appliance Administration Guide
1-24
peer-status—Displays the status for all configured NTP servers and peers.
peers—Displays a listing of all NTP peers.
statistics—Displays the NTP statistics.
io—Displays the input/output statistics.
local—Displays the counters maintained by the local NTP.
memory—Displays the statistic counters related to the memory code.
peer—Displays the per-peer statistics counter of a peer.
ip_address—Displays the peer statistics for the specified IP address.
describes the fields in the show ntp peer-status command output.
Field Descriptions for the show ntp peer-status Command
Description
Number of associated peers
IP addresses that correspond to the remote server and
peer entries listed in the configuration file
IP addresses that correspond to the local server and peer
entries listed in the configuration file
The stratum
The poll interval (in seconds)
The status of the reachability register (see RFC-1305)
in octal
The latest delay (in microseconds)
Chapter 1 Setting Up the ACE
OL-11157-01