Displaying Snmp Statistics - Cisco ACE-4710-K9 Administration Manual

Displaying SNMP Statistics

Displaying SNMP Statistics
Cisco 4700 Series Application Control Engine Appliance Administration Guide
8-50
Use the show snmp commands in Exec mode to display SNMP statistics and
configured SNMP information. By default, this command displays the ACE
contact, ACE location, packet traffic information, community strings, and user
information. You can instruct the ACE to display specific SNMP information by
including the appropriate keyword.
The syntax of this command is as follows:
show snmp [community | engineID | group | host | sessions | user]
The keywords are as follows:
• community—(Optional) Displays SNMP community strings.
engineID—(Optional) Displays the identification of the local SNMP engine
•
and all remote engines that have been configured on the ACE.
group—(Optional) Displays the names of groups on the ACE, the security
•
model, the status of the different views, and the storage type of each group.
host—(Optional) Displays the configured SNMP notification recipient host,
•
User Datagram Protocol (UDP) port number, user, and security model.
sessions—(Optional) Displays the IP address of the targets for which traps or
•
informs have been sent.
user—(Optional) Displays SNMPv3 user information.
•
Table 8-5 describes the fields in the show snmp community command output.
Table 8-5 Field Descriptions for the show snmp Command Output
Field Description
Sys contact Contact name for the SNMP system
Sys location SNMP system location
T
SNMP packets otal number of SNMP packets received by the ACE
input
Bad SNMP Number of packets with an invalid SNMP version
versions
Unknown Number of SNMP packets with an unknown community
community name name
Chapter 8 Configuring SNMP
OL-11157-01