Creating A Layer 3 And Layer 4 Policy Map For Network Management Traffic Received By The Ace - Cisco ACE-4710-K9 Administration Manual

Configuring a Layer 3 and Layer 4 Policy Map
Creating a Layer 3 and Layer 4 Policy Map for Network
Management Traffic Received by the ACE
Cisco 4700 Series Application Control Engine Appliance Administration Guide
4-44
To configure a Layer 3 and Layer 4 policy map that defines the different actions
that are applied to the IP management traffic received by the ACE, use the
policy-map type management first-match configuration command. The ACE
executes the specified action only for traffic that meets the first matching
classification with a policy map. The ACE does not execute any additional
actions.
The syntax of this command is:
policy-map type management first-match map_name
The map_name argument specifies the name assigned to the Layer 3 and Layer 4
network management policy map. Enter an unquoted text string with no spaces
and a maximum of 64 alphanumeric characters.
When you use this command, you will access policy map management
configuration mode.
For example, to create a Layer 3 and Layer 4 network traffic management policy
map, enter:
host1/Admin(config)# policy-map type management first-match
L4_MGMT_POLICY
host1/Admin(config-pmap-mgmt)#
To remove a network traffic management policy map from the ACE, enter:
host1/Admin(config)# no policy-map type management first-match
L4_MGMT_POLICY
Chapter 4 Configuring Class Maps and Policy Maps
OL-11157-01