Cisco ACE-4710-K9 Administration Manual page 329

Chapter 8 Configuring SNMP
Table 8-1 SNMP MIB Support (continued)
MIB Support
CISCO-SYSLOG-MIB
IF-MIB
IP-MIB
SNMPv2-MIB
OL-11157-01
Capability MIB
CISCO-SYSLOG-
CAPABILITY
CISCO-IF-CAPABILITY Reports generic information on interfaces (for
CISCO-IP-CAPABILITY Defines managed objects for managing
CISCO-SNMPv2-
CAPABILITY
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Description
Describes and stores the system messages
(syslog messages) generated by the ACE. The
CISCO-SYSLOG-MIB provides access to the
syslog messages through SNMP. The MIB
also contains a history of syslog messages and
objects to enable or disable the transmission
of syslog notifications.
This MIB does not track messages
Note
that are generated from debug
commands entered through the CLI.
Syslog is described by RFC 3164.
example, VLANs).
The IF-MIB is described in RFC 2863.
The Ethernet data port and
Note
port-channel interfaces are available
only in Admin context. In this case,
the IF-MIB supports all the interfaces
for Admin contexts, while each
individual user context supports only
VLAN and BVI interfaces.
implementations of the IP and its associated
Internet Control Message Protocol (ICMP),
but excludes their management of IP routes.
The IP-MIB is described in RFC 4293.
Provides the Management Information Base
for SNMPv2. The management protocol,
SNMPv2, provides for the exchange of
messages that convey management
information between the agents and the
management stations.
The SNMPv2-MIB is described in RFC 3418.
SNMP Overview
8-19