Cisco ACE-4710-K9 Administration Manual page 32

Using the Setup Script to Enable Connectivity to the Device Manager
policy-map type management first-match first-match
remote_mgmt_allow_policy
class remote_access
interface vlan 2
ip address 192.168.1.10 255.255.255.0
access-group input ALL
service-policy input remote_mgmt_allow_policy
no shutdown
ip route 0.0.0.0 0.0.0.0 172.16.2.1
At the prompt "Would you like to edit the configuration? (yes/no) [n]:", enter one
Step 12
of the following replies:
•
•
At the prompt "Use this configuration? (yes/no) [y]":, enter one of the following
Step 13
replies:
•
•
At the prompt "Would you like to save the running-config to startup-config?
Step 14
(yes/no) [n]:, enter one of the following replies:
•
•
Cisco 4700 Series Application Control Engine Appliance Administration Guide
1-6
permit
Type y to modify the configuration at the CLI.
Type n to accept the configuration without any additional changes. This
setting is the default.
Type y to instruct the ACE to boot using the newly created
running-configuration file. This is the default.
Type n to bypass using the newly created running-configuration file and boot
with an empty configuration.
Type y to save the running-configuration to the startup-configuration file.
Type n to bypass saving the running-configuration to the
startup-configuration file.
Chapter 1 Setting Up the ACE
OL-11157-01