Configuring a Layer 3 and Layer 4 Policy Map
Specifying a Layer 3 and Layer 4 Traffic Class With the Traffic
Policy
Cisco 4700 Series Application Control Engine Appliance Administration Guide
4-46
The text argument specifies the description that you want to provide. Enter an
unquoted text string with a maximum of 240 alphanumeric characters.
For example, to specify a description that the policy map is to filter network traffic
to a VIP, enter:
host1/Admin(config-pmap)# description filter traffic matching a VIP
To remove the description from the class map, enter:
host1/Admin(config-pmap)# no description
To specify a Layer 3 and Layer 4 traffic class created with the class-map
command to associate network traffic with the traffic policy, use the class
command in policy map configuration mode.
The syntax of this command is:
class map_name
The map_name argument specifies the name of a previously defined Layer 3 and
Layer 4 traffic class, configured with the class-map command, to associate traffic
to the traffic policy. Enter an unquoted text string with no spaces and a maximum
of 64 alphanumeric characters.
When you use this command, you will access policy map class configuration
mode.
For example, to specify an existing class map within the Layer 3 and Layer 4
policy map, enter:
host1/Admin(config-pmap)# class L4_SLB_VIP_CLASS
host1/Admin(config-pmap-c)#
To remove a class map from a Layer 3 and Layer 4 policy map, enter:
host1/Admin(config-pmap)# no class L4_SLB_VIP_CLASS
To manually insert the class map ahead of a previously specified class map, use
the class command with the insert-before keyword. However, the ACE does not
save this reordering as part of the configuration.
Chapter 4
Configuring Class Maps and Policy Maps
OL-11157-01