Cisco ACE-4710-K9 Administration Manual page 132

Class Map and Policy Map Configuration Quick Start
Table 4-4
Task and Command Example
7.
8.
9.
Table 4-5
a Layer 3 and Layer 4 network management policy map and to apply the policy to
one or all of the VLAN interfaces associated with the context. Each step includes
the CLI command required to complete the task.
Cisco 4700 Series Application Control Engine Appliance Administration Guide
4-18
Layer 3 and Layer 4 Traffic Policy Map Configuration
Quick Start (continued)
Specify the policy map actions that you want applied to the Layer 3 and
Layer 4 network traffic passing through the ACE.
For example, to specify an SLB action for the Layer 3 and Layer 4 policy
map, enter:
host1/Admin(config-pmap)# class L4_AUTH_CLASS
host1/Admin(config-pmap-c)# loadbalance vip inservice
host1/Admin(config-pmap-c)# loadbalance policy L7SLBPOLICY
host1/Admin(config-pmap-c)# exit
Attach the Layer 3 and Layer 4 traffic policy to a single VLAN interface or
globally to all VLAN interfaces in the same context.
host1/Admin(config)# interface vlan 50
host1/Admin(config-if)# ip address 192.168.1.100 255.255.0.0
host1/Admin(config-if)# service-policy input L4_SLB_POLICY
(Optional) Save your configuration changes to Flash memory.
host1/Admin(config)# exit
host1/Admin# copy running-config startup-config
provides a quick overview of the steps required to create and configure
Chapter 4 Configuring Class Maps and Policy Maps
OL-11157-01