Cisco ACE-4710-K9 Administration Manual page 308

Displaying Redundancy Information
Table 7-6
Field
My State
Cisco 4700 Series Application Control Engine Appliance Administration Guide
7-56
Field Descriptions for the show ft track Command Output
(continued)
Description
State of the FT group member in the local ACE. Possible
states are:
FSM_FT_STATE_INIT—Initial state for each
•
member (local and peer) of an FT group. The
configuration for the FT group exists but the group is
not yet in service.
FSM_FT_STATE_ELECT—State that the local group
•
member enters when you configure the inservice
command for an FT group. Through the election
process, the local context negotiates with its peer
context in the FT group to determine their states. One
member enters the ACTIVE state and the other
member enters the STANDBY_CONFIG state.
FSM_FT_STATE_ACTIVE—State that indicates that
•
the local member of the FT group is active and
processing flows.
FSM_FT_STATE_STANDBY_COLD—State that
•
indicates if either the FT VLAN is down but the peer
device is still alive, or the configuration or application
state synchronization failed. When a context is in this
state and a switchover occurs, the transition to the
ACTIVE state is stateless.
FSM_FT_STATE_STANDBY_CONFIG—State that
•
indicates that the local standby context is waiting to
receive configuration information from its active peer
context in the FT group. The active peer context
receives a notification to send a snapshot of its
running-configuration file to the local standby context.
FSM_FT_STATE_STANDBY_BULK—State that
•
indicates that the local standby context is waiting to
receive state information from its active peer context.
The active peer context receives a notification to send
a snapshot of the current state information for all
applications to the standby context.
Chapter 7 Configuring Redundant ACE Appliances
OL-11157-01