Table of Contents
Advertisement
Redundancy Configuration Quick Start
Table 7-1
Task and Command Example
6.
7.
8.
9.
10.
11.
12.
13.
Cisco 4700 Series Application Control Engine Appliance Administration Guide
7-10
Redundancy Configuration Quick Start (continued)
Create at least one FT group on each ACE.
host1/Admin(config)# ft group 1
host1/Admin(config-ft-group)#
Associate a context with each FT group. You must associate the local
context and the corresponding peer context with the same FT group.
host1/Admin(config-ft-group)# associate-context C1
Associate the peer context with the FT group.
host1/Admin(config-ft-group)# peer 1
(Optional) Configure the priority of the FT group on the local appliance.
host1/Admin(config-ft-group)# priority 100
(Optional) Configure the priority of the FT group on the peer appliance.
host1/Admin(config-ft-group)# peer priority 200
Place the FT group in service.
host1/Admin(config-ft-group)# inservice
host1/Admin(config-ft-group)# exit
(Optional) Configure one or more critical objects (gateways or hosts, or
interfaces) to track for switchover. For example, to configure a critical
interface for tracking, enter:
host1/Admin(config)# ft track interface TRACK_VLAN100
host1/Admin(config-ft-track-intf)# track-interface vlan 100
host1/Admin(config-ft-track-intf)# peer track-interface vlan 200
host1/Admin(config-ft-track-intf)# priority 50
host1/Admin(config-ft-track-intf)# peer priority 150
host1/Admin(config-ft-track-intf)# exit
(Optional) Enable autosynchronization of the running- and/or
startup-configuration file from the active to the standby context.
host1/Admin(config)# ft auto-sync running-config
host1/Admin(config)# ft auto-sync startup-config
Chapter 7
Configuring Redundant ACE Appliances
OL-11157-01
Hide quick links:
Advertisement
Table of Contents
