Defining A Class Map Description - Cisco ACE-4710-K9 Administration Manual

Configuring SNMP Management Traffic Services

Defining a Class Map Description

Cisco 4700 Series Application Control Engine Appliance Administration Guide
8-40
The CLI displays the class map management configuration mode. To classify the
remote SNMP protocol management traffic received by the ACE, include one or
more of the associated commands to configure the match criteria for the class
map:
description—See the
•
match protocol—See the
•
You may include multiple match protocol commands in a class map.
For example, to allow SNMP access between the ACE and the host located at IP
address 192.168.1.1 255.255.255.0, enter:
host1/Admin(config)# class-map type management match-all
SNMP-ALLOW_CLASS
host1/Admin(config-cmap-mgmt)# match protocol snmp source-address
192.168.1.1 255.255.255.0
host1/Admin(config-cmap-mgmt)# exit
To remove a Layer 3 and Layer 4 SNMP protocol management class map from the
ACE, enter:
host1/Admin(config)# no class-map type management match-all
SNMP-ALLOW_CLASS
Use the description command to provide a brief summary about the Layer 3 and
Layer 4 remote management class map.
Access the class map management configuration mode to specify the description
command.
The syntax of this command is as follows:
description text
Use the text argument to enter an unquoted text string with a maximum of
240 alphanumeric characters.
"Defining a Class Map Description"
"Defining SNMP Protocol Match Criteria"
Chapter 8 Configuring SNMP
section
section
OL-11157-01