Defining A Class Map Description - Cisco ACE-4710-K9 Administration Manual

Chapter 9 Configuring the XML Interface
R E V I E W D R A F T - C I S C O C O N F I D E N T I A L

Defining a Class Map Description

OL-11157-01
The CLI displays the class map management configuration mode. To classify the
remote HTTP or HTTPS management traffic received by the ACE, include one or
more of the following commands to configure the match criteria for the class map:
description—Se the
•
match protocol—See the
•
Criteria" section
You may include multiple match protocol commands in a class map.
For example, to allow HTTPS access between the ACE HTTP server and the
management client located at IP address 192.168.1.1 255.255.255.255, enter:
host1/Admin(config)# class-map type management match-all
XML-HTTPS-ALLOW_CLASS
host1/Admin(config-cmap-mgmt)# match protocol xml-https source-address
192.168.1.1 255.255.255.255
To remove a Layer 3 and Layer 4 network management class map from the ACE,
enter:
host1/Admin(config)# no class-map type management match-all
XML-HTTPS-ALLOW_CLASS
Use the description command to provide a brief summary about the Layer 3 and
Layer 4 class map.
Access the class map configuration mode to specify the description command.
The syntax of this command is:
description text
Use the text argument to enter an unquoted text string with a maximum of
240 alphanumeric characters.
For example, to specify a description that the class map is to allow HTTPS access,
enter:
host1/Admin(config)# class-map type management match-all
XML-HTTPS-ALLOW_CLASS
host1/Admin(config-cmap-mgmt)# description Allow HTTPS as the XML
transfer protocol
Cisco 4700 Series Application Control Engine Appliance Administration Guide
Configuring HTTP and HTTPS Management Traffic Services
"Defining a Class Map Description"
"Defining HTTP and HTTPS Protocol Match
section
9-15