Creating A Layer 3 And Layer 4 Policy Map; Creating A Layer 3 And Layer 4 Policy Map For Snmp Network Management Traffic Received By The Ace; Specifying A Layer 3 And Layer 4 Traffic Class With The Traffic Policy; Specifying Layer 3 And Layer 4 Policy Actions - Cisco ACE-4710-K9 Administration Manual

Configuring SNMP Management Traffic Services

Creating a Layer 3 and Layer 4 Policy Map

Creating a Layer 3 and Layer 4 Policy Map for SNMP Network Management Traffic
Received by the ACE
Cisco 4700 Series Application Control Engine Appliance Administration Guide
8-42
mask—Subnet mask of the client in dotted-decimal notation (for example,
•
255.255.255.0).
For example, to specify that the class map allows SNMP access to the ACE from
source address 192.168.10.1 255.255.255.0, enter:
host1/Admin(config)# class-map type management SNMP-ALLOW_CLASS
host1/Admin(config-cmap-mgmt)# match protocol snmp source-address
192.168.10.1 255.255.255.0
To deselect the specified SNMP protocol match criteria from the class map, enter:
host1/Admin(config-cmap-mgmt)# no match protocol snmp
A Layer 3 and Layer 4 policy map defines the actions executed on SNMP network
management traffic that matches the specified classifications. This section
contains the following topics:
Creating a Layer 3 and Layer 4 Policy Map for SNMP Network Management
•
Traffic Received by the ACE

Specifying a Layer 3 and Layer 4 Traffic Class with the Traffic Policy

•

Specifying Layer 3 and Layer 4 Policy Actions

•
To configure a Layer 3 and Layer 4 policy map that permits the ACE to receive
the SNMP management protocol, use the policy-map type management
command in configuration mode. The ACE executes the action for the first
matching classification. The ACE does not execute any additional actions.
The syntax of this command is as follows:
policy-map type management first-match map_name
The map_name argument specifies the name assigned to the Layer 3 and Layer 4
network management policy map. Enter an unquoted text string with no spaces
and a maximum of 64 alphanumeric characters.
Chapter 8 Configuring SNMP
OL-11157-01