Setting An Ip Address - SMC Networks 6726AL2 Management Manual

I C
NITIAL ONFIGURATION
2. Type "configure" and press <Enter>.
3. Type "username guest password 0 password," for the Normal Exec
level, where password is your new password. Press <Enter>.
4. Type "username admin password 0 password," for the Privileged Exec
level, where password is your new password. Press <Enter>.
Note: '0' specifies the password in plain text, '7' specifies the
Username: admin
Password:
Console#configure
Console(config)#username guest password 0 [password]
Console(config)#username admin password 0 [password]
Console(config)#

Setting an IP Address

You must establish IP address information for the switch to obtain
management access through the network. This can be done in either of the
following ways:
Manual — You have to input the information, including IP address and
subnet mask. If your management station is not in the same IP subnet as
the switch, you will also need to specify the default gateway router.
Dynamic — The switch sends IP configuration requests to BOOTP or
DHCP address allocation servers on the network.
2-6
password in encrypted form.
CLI session with the SMC6726AL2 is opened.
To end the CLI session, enter [Exit].