Configuring Interface Connections - SMC Networks 6726AL2 Management Manual

C
ONFIGURING THE
CLI – This example shows the connection status for Port 5.
Console#show interfaces status ethernet 1/5
Information of Eth 1/5
Basic information:
Port type:
Mac address:
Configuration:
Name:
Port admin:
Speed-duplex:
Capabilities:
Broadcast storm:
Broadcast storm limit:
Flow control:
Lacp:
Port security:
Max MAC count:
Port security action:
Current status:
Link status:
Operation speed-duplex: 100full
Flow control type:
Console#

Configuring Interface Connections

You can use the Port Configuration or Trunk Configuration page to
enable/disable an interface, set auto-negotiation and the interface
capabilities to advertise, or manually fix the speed, duplex mode, and flow
control.
Command Attributes
• Name – Allows you to label an interface. (Range: 1-64 characters)
• Admin – Allows you to manually disable an interface. You can disable
an interface due to abnormal behavior (e.g., excessive collisions), and
then reenable it after the problem has been resolved. You may also
disable an interface for security reasons.
• Speed/Duplex – Allows you to manually set the port speed and
duplex mode. (i.e., with auto-negotiation disabled)
• Flow Control – Allows automatic or manual selection of flow control.
3-90
S
WITCH
100TX
00-30-f1-47-58-46
Up
Auto
10half, 10full, 100half, 100full
Enabled
32000 octets/second
Disabled
Disabled
Disabled
0
None
Down
None
4-152