Mac-Address-Table Aging-Time - SMC Networks 6726AL2 Management Manual

C L
OMMAND INE
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• The MAC Address Table contains the MAC addresses associated with
each interface. Note that the Type field may include the following
types:
- Learned - Dynamic address entries
- Permanent - Static entry
- Delete-on-reset - Static entry to be deleted when system is reset
• The mask should be hexadecimal numbers (representing an equivalent
bit mask) in the form xx-xx-xx-xx-xx-xx that is applied to the specified
MAC address. Enter hexadecimal numbers, where an equivalent
binary bit "0" means to match a bit and "1" means to ignore a bit. For
example, a mask of 00-00-00-00-00-00 means an exact match, and a
mask of FF-FF-FF-FF-FF-FF means "any."
• The maximum number of address entries is 8191.
Example
Console#show mac-address-table
Interface Mac Address
--------- ----------------- ---- -----------------
Eth 1/1 00-00-E8-49-5E-DC
Trunk 2 00-E0-29-8F-AA-1B
Console#

mac-address-table aging-time

This command sets the aging time for entries in the address table. Use the
no form to restore the default aging time.
Syntax
mac-address-table aging-time seconds
no mac-address-table aging-time
seconds - Aging time. (Range: 10-30000 seconds; 0 to disable aging)
4-180
I
NTERFACE
Vlan Type
1 Delete-on-reset
1 Learned