Table of Contents
Advertisement
CLI
4 System Connection and IP Address
4.1
4.1.1
Step 1 Attach the RJ45 connector on the cable to the RJ45 connector on the console port of the
Step2 Connect the other end of the cable to one of the serial ports on your workstation.
Step3 Open your terminal emulation software and configure the COM port settings to which you
4.1.2
36
System Connection
After installing the system, the switch is supposed to examine that each port is rightly
connected to network and management PC. You can connect to the system to configure
and manage the switch. This section provides instructions how to change password for
system connection and how to connect to the system through telnet as the following order.
•
Connecting to the Console Port
System Login
•
Password for Privileged EXEC Enable Mode
•
Changing Login Password
•
Login Password Recovery Process
•
Management for System Account
•
Limiting Number of Users
•
•
Auto Log-out
Telnet Access
•
System Rebooting
•
Connecting to the Console Port
To begin setup, you must connect the Console to the RJ45 Console port. To connect the
cable, perform the following steps:
switch.
have connected the cable. The settings should be set to match the default settings for the
switch, which are:
• 9600 bps
• 8 data bits
• 1 stop bit
• No parity
• No flow control
System Login
After installing the switch, finally make sure that each port is correctly connected to PC for
network and management. And then, turn on the power and boot the system as follows.
Step 1
When you turn on the switch, booting will be automatically started and login prompt will
be displayed.
SWITCH login:
Management Guide
TigerAccess™ EE
SMC7824M/VSW
Advertisement
Table of Contents
