Enabling Lacp On Selected Ports - SMC Networks 6726AL2 Management Manual

C
ONFIGURING THE
CLI – This example creates trunk 2 with ports 1 and 2. Just connect these
ports to two static trunk ports on another switch to form a trunk.
Console(config)#interface port-channel 2
Console(config-if)#exit
Console(config)#interface ethernet 1/1
Console(config-if)#channel-group 2
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#channel-group 2
Console(config-if)#end
Console#show interfaces status port-channel 2
Information of Trunk 2
Basic information:
Port type:
Mac address:
Configuration:
Name:
Port admin:
Speed-duplex:
Capabilities:
Flow control:
Port security:
Max MAC count:
Current status:
Created by:
Link status:
Port operation status:
Operation speed-duplex: 100full
Flow control type:
Member Ports: Eth1/1, Eth1/2,
Console#

Enabling LACP on Selected Ports

Command Usage
• To avoid creating a loop in the
network, be sure you enable LACP
before connecting the ports, and also
disconnect the ports before disabling
LACP.
• If the target switch has also enabled
LACP on the connected ports, the
trunk will be activated automatically.
3-96
S
WITCH
100TX
00-00-E8-AA-AA-01
Up
Auto
10half, 10full, 100half, 100full
Disabled
Disabled
0
User
Up
Up
None
dynamically
enabled
active
links
configured
members
4-144
4-144
4-165
4-152
backup
link