C
ONFIGURING THE
Command Attributes
•
Priority – CoS value. (Range: 0-7, where 7 is the highest priority)
•
Traffic Class
highest CoS priority queue)
Web – Click Priority, Traffic Classes. The current mapping of CoS values
to output queues is displayed. Assign priorities to the traffic classes (i.e.,
output queues), then click Apply.
CLI – The following example shows how to change the CoS assignments.
Console(config)#interface ethernet 1/1
Console(config-if)#queue cos-map 0 0
Console(config-if)#queue cos-map 1 1
Console(config-if)#queue cos-map 2 2
Console(config-if)#end
Console#show queue cos-map ethernet 1/1
Information of Eth 1/1
CoS Value
Priority Queue: 0 1 2 1 2 2 3 3
Console#
Note: Mapping specific values for CoS priorities is implemented as an
interface configuration command, but any changes will apply to
the all interfaces on the switch.
14. CLI shows Queue ID.
3-168
S
WITCH
14
– Output queue buffer. (Range: 0-3, where 3 is the
Figure 3-73 Traffic Classes
: 0 1 2 3 4 5 6 7
4-144
4-226
4-228