Command Groups - SMC Networks 6726AL2 Management Manual

C L
OMMAND INE

Command Groups

The system commands can be broken down into the functional groups
shown below
Command Group Description
Line
General
System
Management
Flash/File
Authentication
Access Control List Provides filtering for IP frames (based on address,
SNMP
Interface
Mirror Port
Rate Limiting
Link Aggregation
4-12
I
NTERFACE
.
Table 4-4 Command Groups
Sets communication parameters for the serial port
and Telnet, including baud rate and console time-out
Basic commands for entering privileged access
mode, restarting the system, or quitting the CLI
Controls system logs, system passwords, user name,
browser management options, and a variety of other
system information
Manages code image or switch configuration files
Configures logon access using local or remote
authentication; also configures port security and
IEEE 802.1X port access control
protocol, TCP/UDP port number or TCP control
code) or non-IP frames (based on MAC address or
Ethernet type)
Activates authentication failure traps; configures
community access strings, and trap managers; also
configures IP address filtering
Configures the connection parameters for all
Ethernet ports, aggregated links, and VLANs
Mirrors data to another port for analysis without
affecting the data passing through or the
performance of the monitored port
Controls the maximum rate for traffic transmitted or
received on a port
Statically groups multiple ports into a single logical
trunk; configures Link Aggregation Control
Protocol for port trunks
Page
4-14
4-26
4-32
4-86
4-94
4-117
4-136
4-142
4-157
4-159
4-161