Setting Passwords; Setting An Ip Address - SMC Networks SMC TigerStack III SMC6824M Management Manual

4. The session is opened and the CLI displays the "Console#" prompt
indicating you have access at the Privileged Exec level.

Setting Passwords

Note: If this is your first time to log into the CLI program, you should
define new passwords for both default user names using the
"username" command, record them and put them in a safe place.
Passwords can consist of up to 8 alphanumeric characters and are case
sensitive. To prevent unauthorized access to the switch, set the passwords
as follows:
1. Open the console interface with the default user name and password
"admin" to access the Privileged Exec level.
2. Type "configure" and press <Enter>.
3. Type "username guest password 0 password," for the Normal Exec
level, where password is your new password. Press <Enter>.
4. Type "username admin password 0 password," for the Privileged Exec
level, where password is your new password. Press <Enter>.
Username: admin
Password:
CLI session with the SMC6824M is opened.
To end the CLI session, enter [Exit].
Console#configure
Console(config)#username guest password 0 [password]
Console(config)#username admin password 0 [password]
Console(config)#

Setting an IP Address

You must establish IP address information for the switch to obtain
management access through the network. This can be done in either of the
following ways:
Manual — You have to input the information, including IP address and
subnet mask. If your management station is not in the same IP subnet as
the switch, you will also need to specify the default gateway router.
B C
ASIC ONFIGURATION
2-7