Ip Interface Commands; Ip Address; Table 4-67 Ip Interface Commands - SMC Networks 6726AL2 Management Manual

IP Interface Commands

An IP addresses may be used for management access to the switch over
your network. The IP address for this switch is obtained via DHCP by
default. You can manually configure a specific IP address, or direct the
device to obtain an address from a BOOTP or DHCP server when it is
powered on. You may also need to a establish a default gateway between
this device and management stations or other devices that exist on another
network segment.
Command

ip address

ip default-gateway Defines the default gateway through which
ip dhcp restart
show ip interface Displays the IP settings for this device
show ip redirects Displays the default gateway configured for
ping
ip address
This command sets the IP address for the currently selected VLAN
interface. Use the no form to restore the default IP address.
Syntax
ip address {ip-address netmask | bootp | dhcp}
no ip address
• ip-address - IP address
• netmask - Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific subnets.
• bootp - Obtains IP address from BOOTP.
• dhcp - Obtains IP address from DHCP.

Table 4-67 IP Interface Commands

Function
Sets the IP address for the current interface
this switch can reach other subnetworks
Submits a BOOTP or DHCP client request
this device
Sends ICMP echo request packets to another
node on the network
IP I C
NTERFACE
Mode Page
IC
GC
PE
PE
PE
NE,
PE
OMMANDS
4-249
4-251
4-251
4-252
4-253
4-253
4-249