Table of Contents
Advertisement
"community-string" is the string associated with that host. Press
<Enter>.
2. In order to configure the switch to send SNMP notifications, you must
enter at least one snmp-server enable traps command. Type
"snmp-server enable traps type," where "type" is either authentication
or link-up-down. Press <Enter>.
Console(config)#snmp-server enable traps link-up-down
Console(config)#
Saving Configuration Settings
Configuration commands only modify the running configuration file and
are not saved when the switch is rebooted. To save all your configuration
changes in nonvolatile storage, you must copy the running configuration
file to the start-up configuration file using the "copy" command.
To save the current configuration settings, enter the following command:
1. From the Privileged Exec mode prompt, type "copy running-config
startup-config" and press <Enter>.
2. Enter the name of the start-up file. Press <Enter>.
Console#copy running-config startup-config
Startup configuration file name []: startup
\Write to FLASH Programming.
\Write to FLASH finish.
Success.
Console#
B
C
ASIC
ONFIGURATION
2-11
Hide quick links:
Advertisement
Table of Contents
